![]() No character could be peeked because the input sequence has no characters available (end-of-file reached). If there are no more characters to read in the input sequence, or if any internal state flags is set, the function returns the end-of-file value ( EOF), and leaves the proper internal state flags set: The next character in the input sequence, as a value of type int. Then (if good), it reads one character from its associated stream buffer object by calling its member function sgetc, and finally destroys the sentry object before returning.Ĭalling this function sets the value returned by gcount to zero. Internally, the function accesses the input sequence by first constructing a sentry object (with noskipws set to true). If any internal state flags is already set before the call or is set during the call, the function returns the end-of-file value ( EOF). Updates to the server and client side reads satisfied from the client's cache will not cause st_atime updates on the server as there are no server side reads.Returns the next character in the input sequence, without extracting it: The character is left as the next character to be extracted from the stream. This is caused by client side attribute caching, because most if not all NFS clients leave st_atime (last file access time) On NFS file systems, reading small amounts of data will only update the timestamp the first time, 1 (with errno set to EINTR) or to return the number of bytes already read. POSIX allows a read() that is interrupted after reading some data to return ![]() Other errors may occur, depending on the object connected to fd. It may also occur when there is a low-level I/O error while reading from a disk or tape. Ignoring or blocking SIGTTIN or its process group is orphaned. This will happen for example when the process is in a background process group, tries to read from its controlling terminal, and either it is Timerfd_create(2) for further information.ĮIO I/O error. ![]() In buf, the value specified in count, or the current file offset is not suitably aligned.ĮINVAL fd was created via a call to timerfd_create(2) and the wrong size buffer was given to read() see POSIX.1-2001 allows eitherĮrror to be returned for this case, and does not require these constants to have the same value, so a portable application should check for both possibilities.ĮBADF fd is not a valid file descriptor or is not open for reading.ĮFAULT buf is outside your accessible address space.ĮINTR The call was interrupted by a signal before any data was read see signal(7).ĮINVAL fd is attached to an object which is unsuitable for reading or the file was opened with the O_DIRECT flag, and either the address specified In this case it is left unspecified whether theĮrrors EAGAIN The file descriptor fd refers to a file other than a socket and has been marked nonblocking ( O_NONBLOCK), and the read would block.ĮAGAIN or EWOULDBLOCK The file descriptor fd refers to a socket and has been marked nonblocking ( O_NONBLOCK), and the read would block. On error, -1 is returned, and errno is set appropriately. ![]() It is not an error if this number is smaller than the number of bytes requested this may happen for example because fewerīytes are actually available right now (maybe because we were close to end-of-file, or because we are reading from a pipe, or from a terminal), or because On success, the number of bytes read is returned (zero indicates end of file), and the file If count is greater than SSIZE_MAX, the result is unspecified. In the absence of any errors, or if read() does not check forĮrrors, a read() with a count of 0 returns zero and has no other effects. If count is zero, read() may detect the errors described below. The current file offset is at or past the end of file, no bytes are read, and read() returns zero. On files that support seeking, the read operation commences at the current file offset, and the file offset is incremented by the number of bytes read. Read() attempts to read up to count bytes from file descriptor fd into the
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |